Mercury 200 Optimax Manuel d'installation télécharger pdf (Page 37)

200/225 OPTIMAX DTS

90-10234050 Page 37 / 42

4. Secure propeller nut by bending three of the tabs into the thrust hub grooves.

ob00422

Trim In Pin

WARNING

Avoid possible serious injury or death. Adjust outboard to an intermediate trim position

as soon as boat is on plane to avoid possible ejection due to boat spin out. Do not

attempt to turn boat when on plane if outboard is trimmed extremely in or down and

there is a pull on the steering wheel.

Some boats, particularly some bass boats, are built with a greater than normal transom

angle, which will allow the outboard to be trimmed further in or under. This greater trim

under capability is desirable to improve acceleration, reduce the angle and time spent in

a bow high boat during planing off, and in some cases, may be necessary to plane off a

boat with aft live wells, given the variety of available propellers and height range of engine

installations.

However, once on plane, the engine should be trimmed to a more intermediate position

to avoid a bow-down planing condition called plowing. Plowing can cause bow steering

or over steering and inefficiently consumes horsepower.

or116

a - Tilt pin (not included with engine)

Stainless Steel Tilt Pin 17-49930A1

The owner may decide to limit the trim in. This can be accomplished by purchasing a

stainless steel tilt pin from your dealer and insert it in whatever adjustment hole in the

transom brackets is desired. A non-stainless steel shipping bolt should not be used in this

application other than on a temporary basis.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42

Pas de commentaire

Mercury 200 Optimax Manuel d'installation Page 37