Mercury 200 Optimax Manuel d'installation télécharger pdf (Page 38)

200/225 OPTIMAX DTS

Page 38 / 42 90-10234050

Paddle Wheel Speed Sensor Installation (If Equipped)

Parts Provided

ob01505

a - Spare pin yoke

b - Wire retainer

c - Connector

d - Bracket

e - Paddle wheel

f - Flat washer (2)

g - #10 - 19 mm (3/4 in.) screw (4)

h - Cable cap

i - #6 - 12 mm (1/2 in.) screw (4)

j - Clamp (2)

Selecting Location

Single engine installation - Mount paddle wheel on the transom where the propeller blade

is rotating downward. Usually the right (starboard) side to minimize cavitation. If feasible,

mount at least 50 mm (2 in.) beyond the swing radius of the propeller.

Dual engine installation - Mount the paddle wheel between the engines as close to the

center line (keel) of the boat as possible. On slower, heavier displacement boats,

however, positioning it farther from the keel is acceptable.

NOTE: Do not mount the paddle wheel directly behind any stakes, ribs, intakes or outlets

for live wells or any protrusion that may cause turbulence or cavitation.

ob01506

a - 50 mm (2 in.)

1 2 ... 33 34 35 36 37 38 39 40 41 42

Pas de commentaire

Mercury 200 Optimax Manuel d'installation Page 38