Mercury XR2 Manuel d'installation télécharger pdf (Page 10)

- 10 -

Installing Jet Pump

Hull Cutout

CAUTION

The hull cutout dimensions are critical for proper

sealing between Jet Pump and boat. Measure cut-

out thickness and overall dimensions before at-

tempting a Jet Pump installation.

1. Install tunnel grommet (a) in cut-out of boat. Two

different size grommets are available depending

on cutout thickness.

1/4”

+0.050

–0.030

3/8”

+0.050

–0.030

Use Grommet P/N:

25-820663-250

25-820663-375

2. Route steering cable through the port side hole in

flange of pump housing. Install nut on cable be-

fore routing cable through wear ring.

54900

a - Shift Cable

b - Wear Ring

3. Install tab washer and nut on cable after guiding

through wear ring. Locate tab washer in tab hole.

Coarse cable adjustment is made using these

nuts. Do not tighten until after final steering ad-

justment is made.

54899

c - Tab Hole

d - Nut

e - Tab Washer

4. Route shift cable through the starboard side hole

in flange of pump housing.

IMPORTANT: Ensure that the shift lever in the

control box is set for 76 mm (3 in.) of travel.

NOTE: It is easier to adjust the shift and steering

cables before installing pump unit in boat.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Pas de commentaire

Mercury XR2 Manuel d'installation Page 10