Mercury XR2 Manuel d'installation télécharger pdf (Page 12)

- 12 -

Steering Cable Adjustment

1. Slide bellows assembly over cable and thread on

cable completely. Do Not tighten.

54456

2. Thread cable end adaptor on steering cable 14

turns (to allow for adjustment).

WARNING

Cable end adaptor must be installed a minimum

of nine (9) turns. Failure to install cable end adap-

tor on steering cable a minimum of nine (9) turns

could result in loss of steering control of boat,

personal injury, or death.

54902

a - Cable End Adaptor

3. Center rudder assembly on nozzle.

4. Center steering wheel by turning wheel lock to

lock and positioning wheel midway between

locks.

5. Adjust cable end adaptor until thru-hole in adap-

tor lines up with threaded hole in steering arm.

This is the steering cable fine adjustment. Cable

end adaptor MUST be installed on steering cable

a minimum of nine (9) turns.

6. Attach steering cable to steering arm with bolt,

washer and locknut. Torque nut to 20.3 Nm (180

lb in.).

54902

a - Bellows Nut

b - Forward Stop

c - Bolt

d - Locknut

e - Flat Washer

f - Cable Nuts

7. Tighten cable nuts.

8. Check steering adjustment to ensure that the

helm limits cable travel for maximum left and right

turns. Correct if required.

9. Secure cable nut with tab washer.

10. Apply Perfect Seal to end threads and cable con-

duit end.

Perfect Seal

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Pas de commentaire

Mercury XR2 Manuel d'installation Page 12