Mercury 200 OptiMax DTS Manuel d'installation télécharger pdf (Page 25)

90-898305

1-24

TERMINATION RESISTOR PLACEMENT

NOTE: Termination resistors are designed to reduce noise and provide proper

DC voltage levels on the C.A.N. Bus circuit.

1. Each system must include exactly two (2) termination resistors.

2. Termination resistors must be located at the furthest ends of the main

C.A.N. Bus trunk.

3. The main C.A.N. Bus trunk may not exceed 36.6 m (120 ft.) in length

(measured along the cable). Main C.A.N. Bus Trunk is defined as the length of

cable located between termination resistors.

There are three (3) acceptable methods of adding termination resistors to the

system.

1. Junction box termination resistors.

2. Termination resistor inside the harness with a termination resistor at the

junction box.

3. Termination resistor inside the harness at both ends.

NOTE: Junction box termination resistors are designed to plug directly into

junction box ports.

Notes

_______________________

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 178 179

Pas de commentaire

Mercury 200 OptiMax DTS Manuel d'installation Page 25