Mercury 200 Optimax Spécifications télécharger pdf (Page 138)

OUTBOARD INSTALLATION

126 eng

c. Place a mark on the shift cable against the cable end

guide.

a - Reverse position mark

3. Mark the center on the shift cable midway between the

forward and reverse marks.

a - Center mark

4. Align the cable end guide against this center mark when

installing the cable to the engine.

5. Position the remote control and outboard into neutral

position.

6. Slide the anchor pin forward until resistance is felt, then

slide the anchor pin toward the rear until resistance is felt.

7. Center the anchor pin between these resistance points.

a - Anchor pin

29077

4361

28746

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 148 149

Pas de commentaire

Mercury 200 Optimax Spécifications Page 138