Mercury ALPHA Spécifications télécharger pdf (Page 124)

122

D Loosen the alternator as outlined below. Remove and replace the

alternator belt.

E Replace the spacer block between the bracket assembly and the

engine block. Install the two screws using the flat and lock wash-

ers removed previously. Torque the two screws to 21 lb. ft. (28

N·m).

F Install power steering belt. Adjust tension of both drive belts as

outlined in the following.

Power Steering Pump Drive Belt

4 Remove drive belt as follows:

A Loosen power steering pump attaching bolts and mounting bolts.

B Pivot power steering pump toward engine, as required, until belt

can be removed.

C Install new drive belt on pulleys. Adjust tension as outlined in the

following.

Adjusting Tension - Alternator or Power Steering Pump Drive

Belt

5 Loosen alternator or power steering pump attaching bolts and

mounting bolts (if not already accomplished). Adjust tension as

follows:

A Pivot alternator or power steering pump, away from engine, as re-

quired, until the correct deflection of the belt is obtained at location

specified above.

B After obtaining correct tension, torque the alternator and/or power

steering pump attaching bolts and mounting bolts to specifica-

tions. Refer to “Specifications.”

6 Operate the engine for a short period of time. Recheck belt

adjustment.

INDEX

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 180 181

Pas de commentaire

Mercury ALPHA Spécifications Page 124