Mercury 200 Optimax Manuel d'installation télécharger pdf (Page 16)

200/225/250 OPTIMAX

Page 16 of 38

2. Position remote control and outboard into neutral.

3. Slide the shift cable retainer forward until resistance is felt, then slide cable anchor to-

ward rear until resistance is felt. Center the anchor pin between resistance points.

a-Anchor Pin

4. Align the shift cable end guide with the center mark as instructed in Step 1.

5. Place shift cable on anchor pin. Adjust cable barrel so it slips freely into the barrel holder.

6. Secure shift cable with shift cable retainer.

a-Cable Barrel

b-Shift Cable Retainer

c-Locknut – Tighten locknut then

back off locknut 1/4 turn

d-Nylon Washer

7. Check shift cable adjustments as follows:

a. With remote control in forward, the propshaft should lock solidly in gear. If it does not,

adjust cable barrel closer to cable end guide.

b. Shift remote control into neutral. The propshaft should turn freely without drag. If not,

adjust barrel away from cable end guide. Repeat steps a and b.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Pas de commentaire

Mercury 200 Optimax Manuel d'installation Page 16