Mercury 200 Optimax Manuel d'installation télécharger pdf (Page 20)

200/225/250 OPTIMAX

Page 20 of 38

Prime the oil injection pump as follows:

1. Fill the engine fuel system with fuel. Connect fuel hose and squeeze primer bulb until

it fells firm.

2. Turn the ignition key switch to the “ON” position.

3. Within the first 10 seconds after the key switch has been turned on, move the remote

control handle from neutral into forward gear 3 to 5 times. This will automatically start

the priming process.

NOTE: It may take a few minutes for the pump to complete the priming process.

Purging Air From the Engine Oil Tank

1. Loosen the fill cap on the engine oil tank.

2. Start the engine. Run the engine until the all the air has been vented out of the tank and

oil starts to flow out of the tank. Re-tighten fill cap.

a-Fill Cap

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

Pas de commentaire

Mercury 200 Optimax Manuel d'installation Page 20